Electrical system options:

Bodywork Interface

Cable harness for additional switches

Pre-routed cable harness from bodywork interface to instrument panel for switch installation. The cable harness is connected using connectors under the cover for switches on the instrument panel.

Cable harness from cab to frame

The signals from the bodywork console are lead out to bodywork functions on the chassis frame by means of a cable harness. The cable harness runs from connector C494 in the bodywork console to 1, 2 or 3 DIN connectors on the frame.

Cable harness for bodywork functions – in roof shelf

Pre-routed cable harness from bodywork interface to instrument panel for switch installation. The cable harness is connected using connectors under the cover for switches on the instrument panel.

Junction box on the chassis

Junction box C50 located on the rear part of the chassis. The purpose of the junction box is to make the work easier for bodybuilders.

The light signals that are available in the junction box are intended to be used for electrical connection of extra lamps.

Ordering information:

Variant code 7126A

Configuration of bodywork interface: crane

Crane preparation, with programming for CAN communication and engine speed. No physical parts are included.

Available engine speeds:

  • #1 = 1,000 rpm and maximum vehicle speed 10 km/h.
  • #2 = 1,500 rpm and maximum vehicle speed 10 km/h.
  • #4 = 1,000 rpm, otherwise the default setting.

The default setting is 500 rpm with a maximum vehicle speed of 5 km/h.

Ordering information:

Variant code 7901CA

Configuration of bodywork interface: general

The bodywork interface is prepared for bodywork by the factory making it open to external CAN signals, which saves time for the bodybuilder.

More information:

Variant code 7901GA

Configuration of bodywork interface: mixer unit

Preparation for connection of a control panel at the rear frame end.

The preparation includes programming of the bodywork communication interface for the engine start and stop functions, as well as three selectable engine speeds. A cable harness that can be connected to the control panel is routed to the rear frame end.

Selectable engine speeds that can be controlled from the control panel are:

  • 950
  • 1,300 
  • 1,500

Ordering information:

Variant code 7901MA

Configuration of bodywork interface: tail lift

Preparation in the bodywork interface for safety function that means the engine cannot be started if the tail lift is open.

Ordering information:

Variant code 7901TA